Timber Frame Roof Construction Details

Joists are placed on edge spaced at 400 600mm centres supported by external and internal load bearing walls.

Timber frame roof construction details.

Timber framed and historic buildings may be framed with principal rafters or timber roof trusses. Shipwrights were the original american timber framers. Many people still think that the roof structures of timber framed buildings look like the upside down hulls of boats. An early form of the stud wall only much heavier.

A common form of timber framing for smaller structures was to frame the walls with vertical members raise it then add roof members to enclose. The roof sheathing consisted of inch thick wide pine boards nailed to the purlins and thick enough to resist much sagging. 2 heavy timber construction details. Below is a sketch of the original roof wall structural details for this building.

Trada and approved document part a give guidance on sizes of joists for flat roofs relating to spans and loading. Wood frame or glued laminated arches for roof con struction which spring from the floor line or grade and do not support floor loads shall have members not less than 6 inches nominal in width and 8 inches nominal in depth for the lower half of the height and not less than 6 inches nominal in any dimension for the upper half of the height. Timber framing in america is an art of craftsmanship brought by the settlers in the 1500 s.